[Simh] TMXR: attach lines to separate ports?

[Lars Brinkhoff]

Hello,

I'm running ITS on the PDP-10 simulator. ITS has a built-in
configuration for each DZ11 line. That includes speed, terminal type,
etc.

For example, the GT40 I mentioned in another thread was connected to one
particular line and some applications have built-in knowledge about
this.

As far as I can see, when I connect to the single TXMR TCP port, I get a
dynamically allocated free terminal line. I tried "attach dz0 1234" to
see if I could attach individual DZ11 lines to separate ports, but I
don't think that's supported. There's just one port shared between all
lines, right?

So, if this is the case, is there a way to make TMXR use separate
ports for each line?

[Mark Pizzolato]

I'm running ITS on the PDP-10 simulator. ITS has a built-in configuration for
each DZ11 line. That includes speed, terminal type, etc.
For example, the GT40 I mentioned in another thread was connected to one
particular line and some applications have built-in knowledge about this.
As far as I can see, when I connect to the single TXMR TCP port, I get a
dynamically allocated free terminal line. I tried "attach dz0 1234" to see if I
could attach individual DZ11 lines to separate ports, but I don't think that's
supported. There's just one port shared between all lines, right?
So, if this is the case, is there a way to make TMXR use separate ports for each
line?

Yes. Each line can have its own listen port. See HELP DZ ATTACH

- Mark

[Lars Brinkhoff]

Post by Mark Pizzolato

Post by Lars Brinkhoff
So, if this is the case, is there a way to make TMXR use separate
ports for each line?

Yes. Each line can have its own listen port. See HELP DZ ATTACH

So e.g. ATTACH DZ Line=32,1234

Perfect, thanks!